Hitachi CM-N28000BF, Инструкция по эксплуатации

Страница: 12 / 35

-8-
●
●
●
8 Remove the ring and the cotton.
6 After 3 minutes have elapsed, the device will automatically shut off.
(Auto shutoff function)
The finishing sound (beep beep) will inform you.
●
●
Wipe off the surface of the heating head with a tissue.
Do not use the cotton again once it is used. It might cause problems with your skin.
●
●
1 Attach new cotton to the body with the attachment ring.
Step 2
"HOT MOISTURIZE"
7 After use, make sure to pull out the power adaptor from the electric outlet and the
main body. (Fig. 7)
To continue to use the next mode, do not disconnect the power adaptor.
Pull out holding the plug portion.
●
●
Do not use milky lotion or a gel-like or thick toner.
Saturate the cotton with lotion to the extent that lotion permeates the back of the
cotton.
2 Saturate the cotton with your regular toner.
3 After confirming that the power adaptor is connected to the main body, press the
power switch. (Fig. 8)
●
“Low” on the level indicator lamp lights and “HOT MOISTURIZE” on the mode
indicator lamp starts flashing. If a lamp in another mode is flashing, press the mode
switch button to switch to “HOT MOISTURIZE.”
Every time the level indicator button is pressed, the “LOW”,”MEDIUM” and “HIGH”
of the electrical potential will be switched. There will be no change in vibration
strength. ●
4 Choose "the strength" of electrical potential with the Level switch button. Switch the
"strength" with the Level switch button according to the condition of your skin.
Add more toner when there is no moisture in the cotton or when the device is difficult
to slide.
Do not apply the device on the same area of skin for more than 10 seconds.
If you feel your skin tingling by micro current while using the device, press the level
switch button and switch to "Low."
If you still feel your skin tingling, use the device by adding more toner.
When the "HOT CLEANSING" mode is finished, press the power switch and the
"HOT MOISTURIZE" mode will automatically be set.
This mode cares for skin by allowing moisturizing ingredients of toner permeate into
the skin.
When using cotton
For attaching a cotton puff, see "Preparation before use."
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "LOW."
5 Hold the device with your hand touching the back plate of the body. (Fig. 5)
●
●
6 Apply cotton to the skin and move the device slowly. (Fig. 6)
The mode indicator lamp will turn on and the device will start to vibrate.
The time for use is within 3 minutes.
●
Make sure to hold the body with your hand touching the back plate.