English
26
CAUTION
Prior to cutting operation, make sure the material you are going to cut. If the
material to be cut is expected to generate harmful / toxic dusts, make sure the dust
bag or appropriate dust extraction system is connected with dust outlet tightly.
Wear the dust mask additionally, if available.
○
Before starting to saw, ensure that the saw blade has reached full speed
revolution.
○
Should the saw blade be stopped or made an abnormal noise during
operation, turn o
ff
the switch immediately.
○
Always take care in preventing the power cord from coming near the
revolving saw blade.
○
Using the circular saw with the saw blade facing upwards or sideways is very
hazardous. Such uncommon applications should be avoided.
○
When cutting materials, always wear protective glasses.
○
When
fi
nished with a job, pull out the plug from the receptacle.
MOUNTING AND DISMOUNTING THE SAW BLADE
CAUTION
To avoid serious accident, ensure the switch is in the OFF position, and the power
source is disconnected.
1. Dismounting the saw blade
(1) Set the cutting volume at maximum, and place the
Circular Saw as shown in
Fig. 13
.
(2) Depress the lock lever, lock the spindle, and remove
the hexagonal-socket bolt with the Hex. bar wrench.
(3) While holding the lower guard lever to keep the lower
guard fully retracted into the saw cover, remove the
saw blade.
2. Mounting the Saw Blade
(1) Thoroughly remove any sawdust which has
accumulated on the spindle, bolt and washers.
(2) As shown in
Fig. 14
, the side of Washer (A) with
a projected center the same diameter as the inner
diameter of the saw blade and the concave side of
Washer (B) must be
fi
tted to the saw blade sides.
* Washer (A) is supplied for 2 types of saw blades
with the hole diameters of 16 mm and 30 mm.
(When buying the Circular Saw, one type of
washer (A) is supplied.)
In case the hole diameter of your saw blade
does not correspond to that of washer (A),
please contact the shop where you purchased
the Circular Saw.
Hex. bar wrench
Hexagonal-
socket bolt
Lock lever
Fig. 13
Hexagonal-
socket bolt
Washer (B)
Washer (A)
Saw blade
Spindle
Fig. 14
000Book̲C9U3̲ChS.indb 26
000Book̲C9U3̲ChS.indb 26
2017/04/18 11:14:04
2017/04/18 11:14:04
