DAB RESET
When you move the radio to another part of the country, your pre-tuned and stored DAB stations may no
longer be available. If this is the case then you will need to reset your radio back to its original factory
settings; to perform a DAB reset, please do the following:
1. Press the DAB/FM button to select DAB mode.
2. Press the MENU button once to enter into the “Setup menu”, then rotate the JOG MODE/SELECT
control for selection.
3. When the display shows the “DAB Reset”, press the JOG MODE/SELECT control once, the display will
show “Press SELECT to confirm reset …”.(F10)(F11)
4. Press the JOG MODE/SELECT control again to confirm, the display will show “Scanning …” and it will
perform DAB full scan function.
5. After the scan has finished, the radio will select and display the first alphanumerically found station.
Note: All of your stored DAB presets will be lost once the reset has taken place.
Storing and recalling stored preset stations
In either DAB or FM mode, you can store up to 20 stations to the favourite presets; this will enable you to
get direct access to your favourite stations.
1. To store a preset, first tune to your desired station, then press the PROGRAM button once, the display
will show “PRESET#” and flash.(F8)
2. Press the PS + or PS - button to select your desired station preset number, then press the PROGRAM
button to confirm your selection; the display will show “Preset # saved” in DAB mode.(F9)
3. To recall a preset station, press the PS + or PS - button to select the stations that you have stored; the
display will show “Preset # loaded” in DAB mode.
4. If you press a preset that hasn’t been allocated a station; In DAB mode, the display will show “Preset
# free”.
Note: The stored stations will be saved into its memory and power off will not erase it. Storing a
new station into a preset location will erase the previously stored station in that location.
UK-9
F9
F 8
F10
F11
1. To select FM, press the DAB/FM button, the display will show FM and the frequency.
2. To activate frequency auto search, press and hold the or button until it starts to scan down or up
the frequency band; it will stop automatically once a station has been found.
3. To activate manual search, press the JOG MODE/SELECT control once, when “
← Tuning →” appears
in the display, rotate the JOG MODE/SELECT control until you read the correct frequency or the
reception is at its best.
4. You can also press the or button on the remote control to select your desired frequency.
5. Press the MENU button to toggle select between the FM “STEREO” and “MONO” reception.
FM mode
