Hitachi 51F510 DP43, Руководство по обслуживанию

Страница: 48 / 181

48
DP43
WHITE BALANCE ADJUSTMENT FLOW CHART
START
Cut Off Adj.
Blue defocus Adj.
Sub bright Adj.
Adj. High Light W/B
Adj. Low Light W/B
Sub bright Adj.
Check
Low Light W/B
High Light W/B
FINISH
Repeat two or three times, until no
adjustment is needed
If NOT OK
If OK
2.14 Sub brightness adjustment
Adjustment preparation
(1) Start adjustment after the power is turned ON
for 20 minutes or more.
(2) Receive the color bar signal.
(3) The vertical incident illumination on the screen
should be 20 lux or less. (Room should be dark).
(4) Picture Formats is 16:9 Standard Mode.
Should sink
to black
Should rise
slightly from
black
Adjustment procedure
(1) Go to “Sub Brightness” adjustment in I
2 C
ADJUST mode (press Input and Power button
on Control panel at same time), using CURSOR
G
,
H
and then CURSOR
E
.
(2) Then adjust “Sub Brightness” using CURSOR
F
,
E
to increase or decrease the value,
according to figure. (Visually adjust).
(3) After adjustment, press MENU button to exit I 2 C
ADJUST mode. (Data is stored in memory).
Note:
When selecting SUB-BRIGHTNESS mode the
m icroprocessor sets the CONTRAST and
COLOR to MIN. automatically, but make sure
that the other conditions are center.
Directly observe the screen by eye without using
a mirror.
Y CY G MG R BL
A7 A6 A5 A4 A3 A2 A1
B
C
D
Q I W 100% BLK
W
75%
BACK TO ADJUSTMENTS