-8-
• Mounting the guide sleeve
4. Mounting the exterior parts
Mount the Front Cap
[6]
to the Hammer Case
[7]
.
5. Mounting the guide sleeve
Put the two Steel Balls D3.5
[9]
into the Anvil
[10]
. Mount
Guide Sleeve (D)
[5]
, Guide Spring (D)
[4]
, and Washer (D)
[3]
in this order. Use the J-295 jigs (A) and (B) for retaining
ring (special-purpose tools, Code No. 317060 and 317061) to
mount the Retaining Ring
[2]
in the groove of the Anvil
[10]
.
NOTE: The Retaining Ring [2] may be deformed in the
disassembly procedure and Guide Sleeve (D) [5]
may come off if the deformed Retaining Ring [2]
is reused. Be sure to replace the Retaining Ring
[2] with a new one.
Please purchase the following silicone rubber as necessary.
Item
Registered part name
Net weight
Code No.
Three Bond 1211
Silicone rubber
100 g
306927
Apply specified amount of grease to the following portions.
MOLUB-ALLOY 777-1
• Convex portion (8 mm in dia.) on the Anvil
[10]
• Sliding portion between the Anvil
[10]
and the needle bearing
• Two Steel Balls D5.556
[11]
• Cam groove, oiled groove, and tabs on the Hammer
[12]
• Cam groove and sliding portion of the Spindle
[18]
• Hole (5 mm in dia.) in the Idle Gear Set (2 pcs.)
[19]
• Entire circumference of Needle Roller (A)
[20]
• Twenty-eight Steel Balls D3.175
[13]
• Top surface of the tabs on the Anvil
[10]
and sliding portion of Washer (F)
[8]
• Inner circumference of the needle bearing of the Hammer Case
[7]
Lubrication points and type of lubricant
Press down here.
[2]
[3]
J-295 jig (B) for retaining ring
(special-purpose tool)
J-295 jig (A) for retaining ring
(special-purpose tool)
Type of silicone rubber
