- 2 -
4. Removal of the armature ass'y from the inner cover
As illustrated in Fig. 3, support the Inner Cover
[21] <21>
with a tubular jig, and then push down on the top
of the pinion of the Armature
[26] <26>
.
5. Removal of the stator from the housing
[For DV 13SS, DV 16SS]
First insert a flat-blade screwdriver into the longitudinal cut of a sponge at the rear end of the switch, loosen
both of the upper two setscrews, and then remove the internal wires. Remove the Tapping Screws D4 x 45
[28],
and then slightly tap the end surface of the Housing
[34]
with a wooden hammer. The stator
[29]
can
then be removed from the Housing.
[For DV 13VSS, DV 16VSS]
First, disconnect the internal wires from the upper side of the Switch
<41>
by pulling the faston terminal. To
disconnect the internal wires from the switch, insert a small flat-blade screwdriver into the windows near the
terminals and pull out the internal wires. Remove the Tapping Screws D4 x 45
<28>
and slightly tap the end
surface of the Housing
<34>
with a wooden hammer. The stator
<29>
can then be removed from the
Housing
<34>
.
Fig. 3
Pinion
60 mm dia. to 70 mm in dia.
Push
Inner Cover
[21]<21>
Armature
[26] <26>
Tubular jig
