Hitachi Koki C 12LSH, Инструкция по эксплуатации

Страница: 12 / 76

12
13. Digital display panel (for C12LSH)
Fig. 24
Fig. 25-a
(1) Turning on the digital display switch shows 0° for both
miter and bevel angle, regardless of main unit angle.
(2) Align the main unit angle with the tilt angle (0°) and
miter angle (0°) and hold down their reset buttons for
at least 0.2 seconds.
(3) Turning on the laser marker switch while the digital
display switch is on, lights up the laser marker (On
the C12RSH, only the laser marker switch).
CAUTION
When operating the digital panel, have the motor head
section at the top limit position and the blade stopped.
NOTE
* Before starting to cut, align the main unit to the miter
angle 0° and the bevel angle 0° and hold down the
reset buttons for at least 0.2 seconds. If you press the
digital display switch to ON without aligning the main
unit to 0°, then the figures appearing on the digital
display and the main unit angle will not match.
* The laser marker will not light up if the digital display
switch is turned off (only on C12LSH).
* Do not use the main unit near equipment that
generates electrical noise such as generators.
Electrical noise might cause faulty readings or
operation on the digital display.
Miter angle window
(Displays arrows show angle and
direction that turntable is rotating.
Left is
←
Right is
→
.)
Miter angle reset button
Bevel angle window
(Displays arrows showing motor
head bevel angle and bevel
direction. Left is
←
Right is
→
.)
Bevel angle reset button
Back light ON/OFF switch (Press and the
switch illuminates. Press again and the
lighting turns off.)
CAUTION
If the figure shown on the miter angle digital display
is different from the positive stop angle (for example,
45.0°
→
45.5°, 31.6°
→
32.0°) then the positive stop
has probably deviated slightly from its correct
position. If this happens, do as follows.
(1) Move the turntable left and right with the side handle
loosened, and set the turntable to the correct position.
(2) If the figures on the display and positive stop still do not
match, then return the turntable to the 0° position. Next
move the turntable left and right with the side handle
loosened as shown in
Fig. 25-b . After setting it to the
correct position 0°, press the reset button again as shown
in
Fig. 24 .
Move the turntable left and right with the side
handle loosened and set it to the correct position.
Fig. 25-b
NOTE
Check and make sure on a periodic basis if the position
of the laser line is in order. As regards the checking
method, draw a right-angle ink line on the workpiece
with the height of about 20 mm and the width of 150
mm, and check that the laser line is in line with the
ink line [The deviation between the ink line and the
laser line should be less than the ink line width (0.5
mm)]. (
Fig. 23 )
Laser marker switch
Digital display switch
(for C12LSH)
(Also serves as laser marker
power switch.)
Turntable
Side handle
01Eng_C12LSH_ChT 2/8/07, 17:48 12