Hisense RF200D4CSE, Руководство пользователя

Страница: 8 / 49

3. Separate the two connectors on the
left side door. To remove the wire
connector, press the top of the
connector (B) and separate it from the
other one. To remove the water coupler
from the hinge, twist and pull the clips
from the coupler.
Remove the water line (C) while
pressing the movable part (D) of the
water line coupler.
8
4. Remove the 3 screws (E) fixed on
the hinges, with a Wrench (8mm) and
1 ground screws (F) attached to the
hinge with Philips (+) screwdriver.
Remove the upper left door hinge (G).
5. Use our both hands to open the
door more than 90°. Lift it up and
take it off.
6. If necessary, remove the 2 hex head
bolts hinges (I) with an Allen wrench (5 mm).
Remove the lower left door hinge (H).
Replace the Doors
1. If removed, reinstall the bottom hinge.
2. Using two or more people, set the
refrigerator door onto the bottom hinge
.
3. Insert the top hinge into the top of the door.
4. Using the three screws removed earlier,
fasten the top hinge to the top of the cabinet.
NOTE: Left-hand door only, replace the
ground screw into the top hinge, reattach
the wire harness, reconnect the water line,
make sure the clips are properly connected
to the coupler.
5. Repeat steps 1 through 4 to replace the
opposite door.
6. Using the three screws removed earlier,
reinstall the top hinge cover and control
panel to the top of the cabinet.