15
Software Updating
You can update our PDP’s software through a special RS232 cable (shown as below).
This RS232 cable includes a 9 PIN D-SUB FEMALE, a 3.5mm Stereo Earphone plug and 3 wires.
Built the cable as shown.
UPDATING STEPS:
1. Prepare a pc, and install update software.
Install GPROBE5.0 steps
a, install GPROBE5.0
b, COPY GM1601FW file document TO “C:\”
c, COPY three files of GF to chipdb file document
d, use “batch c:\gm1601fw\ISP\batch\ FlashRom_7.txt ”command
2. Connect the cable:
connect the
9 PIN D-SUB FEMALE
end to a computer, and connect the
stereo
earphone plug
end to
RS232
terminal on the back panel of the PDP.
3. Run the application GPROBE5.0,then input command
“batch c:\gm1601fw\ISP\batch\FlashRom_7.txt”.
4. Turn on the PDP and the updating process begins.
(Warning: Must not turn off the
PDP in the updating process!)
5. When the updating finishes, it will display successfully.
6. Turn off the TV, and then turn on TV again.
9 PIN D-SUB FEMALE
3.5 mm Stereo Earphone plug
