Ambient Operating Temperature
-10
℃——
70
℃
storae Temperature
-40
℃——
85
℃
Operation Temperature
5V
±
0.25
4. The display method of Model approved code
In the factory
，
the model approve code is pasted on the back shell in a label.
5. CE Statement
EU DECLARATION OF CONFORMITY
Hisense declares that the radio equipment type Hisense MWB414S .05 is in compliance with Directive
2014/53/EU.
6. FCC Statement
FCC regulatory compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the
user’s
authority to operate the equipment.
This Module complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
Labelling Instruction for Host Product Integrator
Please notice that if the FCC identification number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following: “Contains FCC ID: SARMW604” any similar wordin
g that
expresses the same meaning may be used.
Installation Notice to Host Product Manufacturer
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install module.
The module is limited to installation in mobile application, a separate approval is required for all other operating
configurations, including portable configurations with respect to §2.1093 and difference antenna configurations.
Antenna Change Notice to Host manufacturer
If you desire to increase antenna gain and either change antenna type or use same antenna type certified, a Class II
permissive change application is required to be filed by us, or you (host manufacturer) can take responsibility through
the change in FCC ID (new application) procedure followed by a Class II permissive change application.
FCC other Parts, Part 15B Compliance Requirements for Host product manufacturer
This modular transmitter is only FCC authorized for the specific rule parts listed on our grant, host product manufacturer
is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant
of certification.
Host manufacturer in any case shall ensure host product which is installed and operating with the module is in compliant
with Part 15B requirements.