Hisense IdeaHub Series, Руководство пользователя

Страница: 8 / 12

Before assembling the computer, please check the shape of the OPS-C plug-in terminal, as
shown in the following figure:
OPS-C Terminal assembly tolerance description
(2). Assembly Route Description:
a. Place the Team Collaboration Board vertically or prone (LCD screen facing the ground
side) stably to ensure sufficient operation space around the computer bracket on the back of
the TV.
b. Insert the OPS-C computer into the computer bracket along the route shown in the
figure. Until and fit snugly.
c. Use the computer model with its own screw, tightening torque: 0.5 Nm ≤ M ≤ 0.8 Nm .
(3).
The style after assembly is as follows:
OPS-C computer
Computer stand
Team Collaboration Board
(back)
OPS-C schematic diagram after computer assembly
(
4). Precautions after assembly:
a. After the computer is installed, and should be in a tight fitting state (the same on
the left and right sides).
b. The screws shall be fastened reliably without looseness. The computer doesn't shake.
4.
After the above steps are completed, the TV can be switched on. After power on, the
OPS-C computer starts, carries on the operating system interface, confirms that there is no
abnormality, and the first start is completed.
5. Computer settings:
(1). After the computer is started normally, restart the computer and use the USB keyboard
or the Fkey area on the remote control. Follow the instructions of the computer
Enter the BIOS interface of the computer, and set the following options in the BIOS:
a.
Wakeup by USB KB / MS is set to enabled;
b. Power loss state is set to power off;
Start the computer normally after saving.
(2).
After the computer enters the operating system, enter the control panel of the windows
system and set the following options as follows:
a. The power button is defined as "shut down";
b. Power plan, turn off display: set to never; sleep set to never.
B
A
|A-B| ≤ 1mm