P22 OF 22
Subject to Continuous Engineering Improvement without Prior Notice.
P21 OF 22
Subject to Continuous Engineering Improvement without Prior Notice.
Product-Indoor Unit Brand:
Outdoor Unit Brand:
Product-Indoor Unit Model No.:
Outdoor Unit Model No.:
Product-Indoor Unit Serial No:
Outdoor Unit Serial No.:
Installed at Address:
Street name and number,
City,
State,
Zip code,
Phone No.
Fax No.
Purchased from Distributor Company/Branch Office Located at:
Street name and number,
City,
State,
Zip code,
Phone No.
Fax No.
Indoor Unit
Outdoor Unit
Packaged Unit
(Please Check Whatever Applicable)
Installed by Contractor Company/Branch Office Located at:
Street name and number,
City,
State,
Zip code,
Phone No.
Fax No.
Valid Contracting Company License No.:
Full Name of Installer Technician:
Cell Ph.:
Office Ph.:
Installed on Date (mm/dd/yyyy):
Installer Checklist:
Are you a licensed contractor/technician?
Did you read through the manual(s) prior to installation?
Is unit unpacked and checked by installer for obvious damage?
Source power V/Ph/Hz measured at circuit breaker at the indoor unit:
outdoor unit:
Incoming power V/Ph/Hz measured at terminal block of control Box of indoor unit:
outdoor unit:
Is factory wiring checked all right prior to installation?
Is field wiring following diagram in unit or manual(s)?
Is field wiring following national and local codes?
Are fan wheels checked for smooth rotation free of abnormal noise?
Is coil sealing/vacuum checked and passed prior to installation?
What level vacuum is reached and kept for how long?
Is refrigerant piping length within stated ranges and free from kinks or too much bending?
Is refrigerant leakage/charge/pressure checked all right for the sealed system?
Is refrigerant charged to solid flow right before metering device?
Is condensate drain pan or pipe checked all right free of any leakage?
Do air intake and discharge grills have enough open area free from any blocking?
Are indoor and outdoor unit fans observed being started, running and stopped in right ways?
Is compressor observed being started, running and stopped in right ways?
Are system/unit functions tested and checked to be surely all right?
Is system/unit tested to run for at least 30 minutes?
Did you explain or teach owner(s) or end user(s) clearly the right operation or normal maintenance of the system/unit?
Does your company provide and will follow installation/service warranty policy?
Print Name of Installer:
Print Name of Owner:
Signature of Installer:
Signature of Owner:
Date:
Date:
To Validate This Warranty, Please Mail the Fully Filled and Signed Card to HiSEER Warranty Dept., POB 1559, O'Fallon, MO 63366
Within 7 Calendar Days After Original Installation, or New Home (Unit is Not Used Yet) is Closed, Whichever Comes Later.
LIMITED PRODUCT WARRANTY
REGISTRATION CARD
HiSEER International (HiSEER) products are designed and manufactured free from defects in workmanship and materials for normal use
and maintenance. HiSEER products are designed and manufactured to the qualities to keep installer(s) and user(s) from any trouble
and to bring total comfort to unit(s) owner(s) and end user(s).
HiSEER warrants its products
against any unexpected issues occurred to product itself, though designed and manufactured and
expected to work much longer than the warranted period,
as follows:
1.
Five-year compressor and sealed system
2.
One-year other parts
3.
Ground shipping only
Above warranties valid only if all the following are satisfied:
1.
The unit was installed by authorized technician(s) of state certified or licensed contractor(s) only.
2.
The unit is installed per national and local codes.
3.
The unit is installed following installation instruction coming with HiSEER products.
4.
The unit is fully checked and tested by installer(s) to make sure installed unit functions as expected.
5.
Right operation of the unit is explained clearly to the owner(s) by installer(s).
6.
All fields are filled or checked, signed and dated by both installer(s) and owner(s) on the
LIMITED PRODUCT
WARRANTY REGISTRATION CARD
on the other side of this page.
7.
Registration card must be mailed within 7 calendar days after the original installation is finished or your NEW home (unit is not
checked or used yet) is closed, whichever comes later, by the owner(s) to HiSEER Warranty Registration, POB 1559, O
’
Fallon,
MO 63366.
8.
A full copy of warranty reGistration card must be kept by owner(s) safely along with other documents that come with the product.
No warranty may be valid if any one of above 8 conditions is not fulfilled.
Warranty begins on the date of the original installation or the date of NEW home (unit is not checked or used yet) is closed,
whichever comes later.
As its only responsibility, and your only remedy, HiSEER will furnish replacement part, without charge for the PART(S) and Ground Shipping
ONLY, to replace any part found to be defective due to manufacture workmanship or materials under normal use and maintenance.
Any part replaced pursuant to this warranty is warranted only for the unexpired portion of the warranty term applying to the original part.
These warranties do not apply to any other cost associated with the service, repair or operation of the product
.
For warranty credit, defective product(s) or part(s) must be identified by
HiSEER
’
s distributor(s) or approved HiSEER Service
Center(s)
. In case no distributor(s) or service center(s) available in the area where unit is installed, owner(s) need to contact HiSEER for
assistance before further action is to be taken.
Warranty policy herein DOESN
’
T cover:
1.
Any damage or repairs to properties and person(s) as an incident or consequence of faulty or improper transportation,
installation, operation, maintenance, or service that ISN
’
T physically performed by HiSEER.
2.
Any damage caused by frozen or broken water pipes in the event of equipment failure.
3.
Any damage as a result of floods, fires, winds, lightning, accidents, corrosive atmosphere or other conditions beyond the
control of HiSEER.
4.
Any damage resulted from use of components or accessories not specified, supplied or designated by HiSEER.
5.
Any damage because of failure to start due to interruption and/or inadequate electrical service.
6.
Any products sold or installed outside the United States or Canada.
Any damage due to service performed by third parties, it is the product receivers(s) or owner(s)
’
s responsibility to claim
such damage resulted from these activities to the responsible party:
1.
Transportation, installation and operation.
2.
Normal maintenance and service as described in the installation and operating manual, such as cleaning of the coils, filter,
cleaning and/or replacement and lubrication.
HiSEER keeps on product improvement and such improvement is purposed to further benefit installerS, owners, users and
others. Such improvement or changes, even without notice, including but not limited to specifications, functions, appearance,
sizes, packages or others, of the products are HiSEER
’
s sole right(s). These improvement or changes will not invalidate the
limited warranty stated herein.
For further information about this warranty, contact HiSEER Warranty Registration
LIMITED PRODUCT WARRANTY
POLICIES
Limited Warranty Policy
Warranty Registration
