Installation PTN-4-2/4WEM
9
Release 01 02/2018
Figure 4
Detailed Function Voice Example
2.2.2
Services
A point-to-point '2W/4W Voice' service can be configured in HiProvision via creating a Circuit
Emulation Service (=CES) with protocol type ‘2W/4W Voice’. The incoming analogue signal
will be sampled at a rate of 8 kHz. The digitized voice data will be encapsulated in TDM
packets which will be sent over the Dragon PTN network as Ethernet packets. Following
parameters are needed per service:
CES: Service Type: Circuit Emulation;
Protocol: 2W/4W Voice;
Usage is always CESoPSN;
optional: Hitless Switching;
optional: Single Path;
2.2.3
CES: CESoPSN (Point-to-Point)
CESoPSN (=Circuit Emulation Service over Packet Switched Network)
CESoPSN is a point-to-point service between two voice ports that uses the timeslots of an E1
frame to transport the data over the MPLS-TP Dragon PTN network. One such service can be
configured per port. This service transports the voice data into the first timeslot and the
E&M signaling (=future) in the second timeslot of an E1 frame.
The destination module will receive the transported timeslots from the Dragon PTN network
and regenerate the voice data and the E&M signaling (=future) from it to finally output it on
its voice port.
Each end-point or port must be located in a different node.
CSM
CSM310-A
IFM1
4-2/4WEM
IFM2
4-GC-LW
Switch
ETH
MPLS-TP
Dragon PTN Node
LAN
WAN
4-2/4WEM
CSM
CSM310-A
IFM1
4-2/4WEM
IFM2
4-GC-LW
Switch
ETH
MPLS-TP
Dragon PTN Node
WAN: MPLS-TP (on fiber, copper)
between Dragon PTN nodes
Ethernet
node internal
LAN: Voice link (on copper)
external devices
Voice
Links
Packetized Voice via
CESoPSN
MPLS-TP Dragon PTN Network
WAN (via SFP on fiber)
LAN1
PABX
Voice
Port
Voice
Links
LAN2
Leased Line
Modem