28
5. Using the Remote Control
5.1 Batteries
How to insert the batteries
– Open the cover at the top of the rear side of the handset
– Insert two ‘AAA’ type batteries (1.5V), respecting the indicated po/- signs
– Close the cover
When to replace the batteries
– When the operational range of the handset gets smaller, or when the receiver no longer
responds to each and every command. Always replace both batteries at the same time.
Accident prevention
– Do not recharge, heat or disassemble the batteries
– Make sure the intended polarity alignment is respected
– If the handset is not going to be used for some time, take the batteries out. If not, the batteries
may leak and cause damage to the handset
5.2 Range of Operation
– The operating range of the handset is /- 30 degrees on both the vertical and horizontal
planes of the Infra Red sensor
– Transmission distance does not exceed 7m
* Notes
– When the handset is not operational
Replace the batteries and make sure the receiver is connected to the power supply
– Abnormal operation
Disturbance from peripheral devices may occur. You will need to move the object that is
generating the disturbance.
– Notes for handling
In the event the receiver is exposed to heat or water, operating it could be dangerous. Have the
unit checked by a qualified technician prior to operating it again.
