HiRO H50113, Быстрое руководство по установке

Страница: 34 / 36

Hiro H50113
33

Check the phone cord connection. Make sure that the jack
on the modem labeled Line is connected to an analog phone
wall jack.

The modem cannot recognize the dial tone. This is typical in
some corporate PBXs. Use the ATX1 command in your
setup string to enable Blind Dial.

The modem does not answer an incoming call

Auto-answer function is disabled. Enable the function
through software program or by sending the ATS0=1
command to your modem in terminal mode.

The modem disconnects while online

This may be caused by line interference. Retry the
connection by dialing the numbers several times.

An incoming call may have broken the connection if the
Call-waiting feature is enabled. Disable Call-waiting and
try again.
Garbage characters display on the monitor

Set your modem to the same word length, parity, and stop
bits as the remote modem.

Make sure that your software and modem are set to the
same flow control setting.