HTF-2 FLOOR SANDER ABRASIVE GUIDE
DO NOT OVER-SAND USE ONLY AS HEAVY GRADE ABRASIVE AS IT TAKES TO DO THE
JOB. PROGRESS FROM FIRST GRADE USED THROUGH FOLLOWING GRADES TO
REMOVE ALL VISIBLE SANDING MARKS. DO NOT MISS A GRADE.
6
ABRASIVE GRADE
APPLICATION
FLOOR TYPE
Abrasive Sheet 40G
(Coarse)
Abrasive Sheet 60G
(Medium)
Abrasive Sheet 80G
(Medium)
Abrasive Sheet 120G
(Fine)
Abrasive Sheet 180G
(Extra Fine)
Abrasive Pad 280G
(Finishing)
For the rapid removal of stock and
Use on solid raw wood
where a deep cut is required.
floors.
Not recommended for use on
factory finished or laminate
flooring systems.
In progression from 40 grade to first
Solid raw wood floors, and
sanding on
floors where an existing stain
less stock removal.
or finish is to be completely
removed from the wood prior
to new finish being applied.
Removal of stains and old finish from
the sub surface of the floor after
stripping of surface coatings with 80
grade (medium) abrasive.
Medium stock removal.
Suitable for all floor types,
however, care should be
Rapid removal of surface coatings and
taken on factory pre-finished
finishes.
floors where the integrity of
seals and stains should be
maintained.
Light stock removal and where only a
First sanding of floors that
minor dimensional change is required
require re-finishing without
in the floor surface.
the removal of old surface
coatings and where the
integrity of seals and stains
must be maintained.
Negligible stock removal prior to
Suitable for all floor types.
application of finish.
Preparation for high quality finished
Suitable for all floor types.
Surface.
Use to sand between coats
Flexible backing pad for abrasive
of finish especially water
sheets.
based stains and varnishes.
smooth surfaces requiring
Backing Pad
