HIRED-HAND MEGA-FLOW CONE FAN, Руководство по установке

Страница: 4 / 10

HIRED-HAND MFG., INC.
•
1733 County Road 68
•
Bremen, Alabama 35033
•
PHONE 256-287-1000
•
FAX 256-287-2000
Manual Part No. 4801-5323 Rev 6-08 Page 4 of 10
C O N E I N S T A L L A T I O N
3 6
″
, 4 8
″
5 2
″
Packing List For One (1) Cone Kit Tools Required
Four (4) Cone Sections Four (4) Corner Brackets
One (1) Wire Guard Five (5) 3/8"-16 x 1 Cap Screws
7/16 in. (11 mm) Wrench Ratchet
Sixteen (16) ¼-20 Nuts Ten (10) 3/8" Washers
Sixteen (16) ¼-20 x 3/4 Bolts Five (5) 3/8"-16 Nuts
7/16 in. (11 mm) Socket
Sixteen (16) #14 x 1” TEK Screws Cordless drill and bit
(For Installing TEK screws)
Marker or Scribe
WARNING!
During Cone Installation Be Sure That Fan Motor Is Not Plugged Into Any Power Source.
Always Double Check Power Sources.
1. Lay cone pieces flat with their flanges pointed up.
Refer to Figure 1.
2. For each panel, bend tabs upward in same direction
as flange.
NOTE: Bend tabs by hand. See Inset Figure 1.
3. Arrange panels with flanges and tabs contacting as
shown in
Figure 1. Align holes of flanges and
tabs.
Assembly and Installation of Cone 36
″
,48
″
& 52
″
(See Page 7 for 54
″
Cone)
Outs
ide E
dge
Insid
e Ed
ge
Arrange panels for assembly
with flat sides down, flange
sides up. The bent tabs of
one panel should contact the
flange of adjacent panel.
Tab before
bending
Bend tab upward
Flange
Tabs
Joints
Mounting
Hole For
Wire guard
Figure 1:
Cone Assembly
!