2.
Connect the other end of the charging cable to an available USB port on your
computer or laptop. (The computer or laptop must be powered on to change the
headset.) The red indicator light on the headset is displayed during charging. If the
charging light does not come on, disconnect the charging cable and retry. Full charge
may take up to 1.5 hours.
3.
When the battery is fully charged, the red indicator light on the headset will turn off.
4.
Disconnect the charging cable from the headset and computer or laptop.
The fully charged battery will power the headset for up to 3 hours of talk time or up to 150
hours of standby time. Please note these values may vary depending on the various usage
scenarios and with different mobile phones. When the battery is running low on power, the
red indicator light will start to flash.
Turn the headset ON / OFF
1.
To switch the headset on, press and hold the Answer/End key for 3 seconds. The
blue indicator light will start to blink.
2.
To switch the headset off, press and hold the Answer/End key for 3 seconds until the
headset beeps 2 times and the red indicator light displays briefly.
Pairing the headset
1.
Make sure your headset is turned OFF with no lights blinking.
2.
Press the Answer (Talk) key for 7 seconds or until the blue and red lights blink
alternately.
3.
Activate the Bluetooth feature on the mobile phone or Bluetooth compatible device
and set it to search for devices (See the user guide of your mobile phone or device
for instructions).
4.
Select the headset “
HS-BT104
” from the list of found devices.
5.
Enter the pass code “
0000”
to pair the headset to your phone or Bluetooth
compatible device.
6.
If the pairing is successful, the headset’s blue light will flash 3 times briefly for the first
time, followed by a single flash every 7 seconds.
7.
Repeat steps 1 through 6 if pairing is not successful.
Troubleshooting
If you cannot connect the headset to your phone, do as follows:
1.
Ensure the headset is charged then go through the steps listed to pair your headset.
2.
Ensure that the Bluetooth feature is activated on your phone.
3.
Check to ensure the headset is within 10 meters of your mobile phone or Bluetooth
device and that there are no obstructions that may prevent connectivity.
Call Handling
1.
To make a call, use your mobile phone in the normal way when the headset is
connected to your phone. The audio will be directed to the headset.
2.
If your mobile phone supports redialing via Bluetooth headsets, press the volume +
key for 2 seconds to redial the last number called.
3.
If your mobile phone supports voice dialing via Bluetooth headsets, press the Answer/
End key and proceed as described in the user guide of your mobile phone.
4.
To answer a call, press the Answer/End key, or use the mobile phone call answer
button. If the automatic answer function is available on your mobile phone and
enabled, incoming calls will automatically be answered after one ring.
5.
To end a call, press the Answer/End key while in a call, or use the call end button on
your mobile phone.
Adjusting the earphone volume
1.
Press the volume key up to increase or down to decrease the volume during a call.
Battery information
