Hioki DT4251, Инструкция по эксплуатации

Страница: 64 / 106

58
Retaining the Measured Value
4.2 Retaining the Measured Value
The measured value is retained manually or automatically. (The bar
graph is updated.)
• Manually When HOLD is pressed, the measured value is retained.
(HOLD lights up.)
• Automatically When HOLD is pressed and held for at least 1 second,
auto mode starts. When the measured value stabilizes, it
is retained. (HOLD blinks.)
Retaining the measured value manually (HOLD)
To retain the measured value, press .
(HOLD lights up and the measurement value
is retained.)
To cancel the hold state, press it again. (HOLD
goes off.)
Automatically retaining the measured value when
the value stabilizes
Press for at least 1 second.
(HOLD blinks.)
When the measured value stabilizes, a
beeping sound is generated and the value is
retained. (HOLD lights up.)
If
HOLD is pressed again for at least 1 second,
or the input signal exceeds the “Threshold for
auto holding” (p.
59), or when the range is
switched internally, the hold state is canceled.
(HOLD goes off.)
• If the input signal is too small for the relevant range (see “Conditions for auto
holding” (p. 59)), the measured value cannot be automatically retained.
• The measured value will be automatically retained once it stabilizes
within the stable range (which takes approx. 2 seconds) as described
in “Conditions for auto holding” (p.
59).