Hinkley 56 inch HAMPTON, Инструкция по эксплуатации, Страница: 13 / 66

INSTALLING THE LIGHT KIT
1
2
3
4
5
6
7
8
5
NOTE:
Be sure the power is off before installing.
Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 1)
Pass the light wires through the center hole of the plastic
shade.
Place the key holes on the light shade over the 2 screws
previously loosened, turn the light shade until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Remove one of the three screws on the light shade located
on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
Fig. 1 Fig. 2
While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- White to white
- Black to black
Tuck connections neatly into light shade. Place the key holes
on the light kit over the 2 screws previously loosened, turn
the light kit until it locks in place at the narrow section of the
key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
Raise the
plastic shade
against the LED light kit stem and
then thread the nut on securely. Do not overtighten.
Restore power and your light kit is ready for operation.
©2020 Hinkley Lighting, Inc.
|
hinkley.com
|
11
Light
shade
Screws
Screws
Light Kit
light shade
Wire connectors
Plastic shade
Nut
Mounting Hub
(bottom of motor)
Light Wires