HM360 DSC MAX
10
System Config
Back Light Time
LCD Contrast
Key Beep
Torch Color
Version Info
Factory Reset
Language Select
Exit
Enter
Turn the knob to switch the GPS satellite location map.
For System Config
Select the system Config and you are able to see the below
menu to check and adjust the LCD/Key Beep figure,
version info and factory reset.
CONTROLS OPERATION
Power ON/OFF(Knob)
Push the coding knob until a click sound heard the unit will
power on.
The unit will start with Normal mode
- Turn on the 1000Hz tone for 100ms
- Turn on the backlit in full scale for 5 sec
- Recall the last channel number, TX power settings
and operational mode
- If no last channel info, go to Channel 16, TX Power
be Hi
- Volume set level 5 (default),max is level 9
- Squelch set levle 5 (default),max is level 9
Volume
、
Squelch &Channel Select (Knob)
Volume Control (Knob)
Turn the coding knob to control the loudspeaker volume
level.
Clockwise-volume up, anti-clockwise-volume down.
Squelch Control (Knob)
At the radio normal mode to adjust the squelch level, short
press the coding knob will
Flash SQL’s level , clockwise or anti clockwise the coding
knob to select SQL level accordingly.
Channel UP/DOWN (Knob)
At the radio normal mode to adjust Channel Up/Down.
short press the coding knob twice will Flash Channel
Number , clockwise or anti clockwise the coding knob to
select Channel Number according,then short press the
coding knob to exit the setting status.
Special function: Distress Key and Real DSC
Send the Distress message:
Pull the Distress key cover then able to Press the Red key
into the Distress Menu selection. Then select the current
distress situation such as the “Flooding” then press and
hold for 3 seconds, the selected DSC message will be send.
This message also will be resend within 4 minutes, press
the Up key will pause or resume the resend, press
Call/Menu key will resend immediately. Press the
CH/WX/UIC key will exit the current menu and give the
option on cancel of this selected distress alert.
Receive the Distress message:
The HM360 DSC MAX model has two receivers, one
receiver used for receiving/transmit voice and another
receiver used for to continually monitor 70 channels. The
DSC function for HM360 DSC MAX model is operated by
individual way.Even you are using the HM360 DSC MAX
to make the transmit or receive, when the DSC message is
arrived.The HM360 DSC MAX handheld model always
can receive all of the DSC message as a fixed mounted
marine radio.Press the Call/Menu key and select the
receive call log then press the enter to see all received DSC
message.
REC/PLAY key
The record IC can record voice 60 seconds.Short press the
REC key will switch record function enable or disable. If
record function enable and the squelch open, The record IC
will record the receiving voice. Short press PLAY/ LOOP
key will switch play function enable or disable.Long press
PLAY/LOOP key will enter loop play voice in record IC.
WP/GOTO key
Waypoint Navigation
The Navigation function navigates from your current
position to an entered regular Waypoint or MOB waypoint.
16/9 key
At the normal mode ,pressing the 16 / 9 Key (short press to
jump to priority CH16 at High Power and long press to
jump to priority CH9 at High Power) if the current channel
