HIMA HIMax X-MIO 6 01, Руководство пользователя

Страница: 49 / 72

X-MIO 7/6 01 4 Start-up
HI 801 305 E Rev. 5.00 Page 49 of 72
4.5.3 Tab: I/O Submodule DO 02
The
I/O Submodule DO 02
tab contains the following system parameters.
Name R/W Description
Enter these statuses and parameters directly in the Hardware Editor.
Name R
Module name
Output Noise Blanking W Allow output noise blanking performed by the output module
(activated/deactivated).
Default setting: Deactivated (
recommended
)
If a discrepancy exists between the channel's default and
read-back values, the channel switch-off is suppressed.
It is only displayed in the redundancy group tab!
Name Data
type R/W Description
The following statuses and parameters can be assigned global variables and used in the user program.
Submodule OK
BOOL R TRUE: No submodule fault, no channel faults.
FALSE: Submodule fault.
Channel fault (external faults included)
Submodule Status DWORD R Bit-coded submodule status (see Chapter 4.5.9 for coding
details)
Table 28: Tab: I/O Submodule DO 02 in the Hardware Editor
4.5.4 Tab: I/O Submodule DO 02: Channels
The
I/O Submodule DO 02: Channels
tab contains the following system parameters for each
output. Global variables can be assigned to the statuses and parameters with
->
and used in the
user program. The value without
->
must be directly entered.
Name Data type R/W Description
Channel no. --- R Channel number, defined by default
Channel Value
[BOOL] -> BOOL
R Binary value in accordance with the switching level LOW
(dig) and HIGH (dig).
TRUE: Channel energized
FALSE: Channel de-energized
-> Channel OK BOOL R TRUE: Faultless channel
The channel value is valid.
FALSE: Faulty channel
The digital output is de-energized.
-> SC BOOL R TRUE: Short-circuit
FALSE: No short-circuit
SC has no effects on the
-> Channel OK
parameter
Table 29: Tab I/O Submodule DO 02: Channels in the Hardware Editor