15
en
5.4 Requirements to be met by users
●
The tool is intended for professional use.
●
The tool may be operated, serviced and repaired only
by authorized, trained personnel. This personnel must
be informed of any special hazards that may be encoun-
tered.
●
Always concentrate on the job you are doing. Proceed
carefully and do not use the tool if your full attention
is not on the job.
5.5 Personal protective equipment
The user and any other persons in the vicinity must wear
suitable eye protection, a safety helmet, ear protection,
protective gloves and breathing protection.
6. Before use
Ensure that the tool is disconnected from the mains
supply.
6.1 Use of extension cords
Use only extension cords of a type approved for the appli-
cation and with conductors of adequate cross section.
Recommended minimum conductor cross section and
max. cable lengths:
Mains voltage
Conductor cross section
AWG
1.5 mm
2
2.0 mm
2
2.5 mm
2
3.5 mm
2
14 12
100 V
–
20 m
–
30 m
–
–
110–120 V
20 m
25 m
30 m
–
75 ft
125 ft
220–240 V
50 m
–
100 m
–
–
–
Do not use extension cords with 1.25 mm
2
or 16 AWG
conductor cross sections.
6.2 Use of a generator or transformer
This tool may be powered by a generator or transformer
which fulfils the following conditions:
– AC voltage output, power output at least 3200 W
– The operating voltage must be 5% and –15%
of the rated voltage at all times.
– Frequency range 50–60 Hz, never above 65 Hz
– Automatic voltage regulation with starting boost
Never operate other tools or appliances from the generator
or transformer at the same time. Switching other tools
or appliances on and off may cause undervoltage and /
or overvoltage peaks, resulting in damage to the tool.
6.3 Fitting the side handle
1. Fit the side handle and side handle clamp onto the
tool.
2. Secure the side handle by tightening the screw knob.
7. Operation
-CAUTION-
●
The insert tool may become hot during
use.
●
There is a risk of burning the hands.
●
Wear protective gloves when changing
insert tools.
Never use the tool without the side handle.
Use a vice or clamp to secure loose workpieces.
7.1 Adjusting the side handle
1. Unplug the supply cord from the mains socket.
2. Slacken the screw knob on the side handle.
3. Bring the side handle into the desired position.
4. Tighten the screw knob to secure the side handle in
the desired position.
7.2 Fitting the insert tool
-NOTE-
The chisel can be locked in the chuck in 6 different posi-
tions (in 60° increments).
Flat and shaped chisels can thus always be brought into
the optimum position for the job on hand.
1. Unplug the supply cord from the mains socket.
Wear
a safety
helmet
Wear
breathing
protection
Wear
ear
protection
Wear
protective
gloves
Wear
eye
protection