Hilti SPN 6--A22, Оригинальная инструкция по эксплуатации, Страница: 28 / 192

22 English 2253586
*2253586*
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group .
8.1 Changing the punch 8
When changing the punch, also check for wear of the die, punch guide and wear plate (not SPN-CN)
and change these components as well, if they are worn.
1. Remove the accessory tool. → page 20
2. Remove the worn punch from the accessory tool.
3. Grease the new punch and also the punch guide in the accessory tool.
4. If the following equipment exists, also take this action:
Option: SPN­RL
▶
Insert the pushrod extension between the pushrod and the punch and grease it.
5. Install the accessory tool. → page 20
8.2 Changing the die 9
Option: SPN­CN
1. Push the cover ring up and out of the groove.
2. Use a suitable punch to push the straight pin out of the hole.
3. Disengage the die from the carrier pin.
4. Position the new die on the carrier pin.
5. Reinstall the straight pin.
6. Push the cover ring down into the groove and check that it is correctly seated.
8.3 Changing the punch guide 10
Option: SPN­CN
CAUTION
Risk of damage to product and cutting tools!
▶
Clean the threads before installing the securing screws.
▶
Always use the new securing screws supplied and tighten the screws to the specified tightening torque.
1. Remove the die. → page 22
2. Remove the securing screws.
3. Lift off the punch guide.
4. Place the new punch guide in position.
5. Insert the securing screws and tighten them to the specified torque.
Technical data
Tightening torque 3 Nm
6. Reinstall the die.