7.1.2 Fitting the saw blade
3
1.
Pull the battery out of the power tool.
2.
Clean the mounting flange and the clamping
flange.
3.
Fit the mounting flange.
4.
Open the pivoting guard.
5.
CAUTION Only use blades which are suitable
for this saw. Observe the direction-of-rotation
arrow on the saw blade.
Fit the new saw blade.
6.
Fit the outer clamping flange.
7.
Press the drive spindle lockbutton.
8.
Fasten the clamping flange with the clamping
screw by turning it anti-clockwise.
9.
Before using the power tool, check that the saw
blade is securely attached.
7.2 Adjusting the cutting depth
4
The cutting depth can be infinitely adjusted between
0 and 57 mm.
1.
Pull the battery out of the power tool.
2.
Place the power tool on a supporting surface.
3.
Release the cutting depth adjustment clamping
lever.
4.
Lift the power tool in a scissor movement and set
the desired cutting depth by closing the clamping
lever.
7.3 Sawing along a line
The position of the saw blade is indicated by the
mark on the base plate. This allows accurate cuts to
be made. The edge of the line indicator corresponds
to the inside of the saw blade. The viewing window
provides a better view of the cutting line and thus
helps ensure a more accurate cut.
1.
Secure the workpiece to prevent movement.
2.
Position the workpiece so that the saw blade is
free to rotate beneath it.
3.
Check to ensure that the on / off switch on the
power tool is in the “off” position.
4.
Fit the battery into the power tool.
5.
Position the forward section of the saw’s base
plate on the workpiece but do not bring the blade
into contact with the workpiece.
6.
If the switch-on interlock has been pressed,
switch the power tool on by pressing the on/off
button.
7.
Guide the saw along the cutting line on the
workpiece at a suitable speed.
7.4 Sawing using the rip fence (accessory)
Use of the single arm rip fence allows precise cuts to
be made along the edge of the workpiece, or strips of
even width to be cut.
The rip fence can be fitted on either side of the base
plate.
7.5 Fitting / adjusting the parallel guide (rip
fence)
5
1.
Remove the battery from the power tool.
2.
Press the clamp together.
3.
Push the parallel guide (rip fence) into the base
plate as far as you wish.
4.
Release the clamp when the parallel guide is in
the desired position.
7.6 Emptying the chip collector
6
CAUTION
Wear protective gloves when emptying the chip
collector.
The metal chips are sharp-edged and may
be hot.
CAUTION
Empty the chip collector and clean the power tool
before putting it away in the toolbox or other con-
tainer for storage or transport.
Metal chips may
otherwise fall out of the collector and find their way
into the power tool, battery or charger, presenting a
risk of damage or malfunction.
When the power tool is in use you can check with
the aid of the viewing window whether the collector
is full.
1.
Remove the battery from the tool.
2.
Pull the chip collector away from the tool to the
rear.
3.
Swing the two halves of the chip collector apart
and empty out its contents.
4.
Push the chip collector onto the guard until in
engages in position.
7.7 Procedure if the chip / dust channel is
blocked
1.
Remove the battery from the tool.
2.
Remove the chip collector.
3.
Clean the chip / dust channel.
en
12
Содержание SCM 18-A
Страница 3: ...4 6 2 3 5...
