Hilti Nuron TE 500-22, Руководство пользователя

Страница: 16 / 188

10 English 2310393
*2310393*
5.7 Fall arrest 4
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶
Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds
securely.
▶
Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
6 Operation
CAUTION
Risk of injury! Loss of control over the breaker.
▶
Check that the side handle is fitted correctly and tightened securely.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Chisel positioning 5
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶
Do not operate the tool when the selector switch is set to “Chisel positioning”. Turn the function selector
switch until it engages in the “Chiseling” position.
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
1. Switch the product off.
2. Set the function selector switch to the “Chisel positioning” position .
3. Rotate the chisel to the desired position.
4. Turn the function selector switch until it engages in the “Chiseling”
position.
▶
The product is ready for use.
6.1.1 Chiseling
1. Set the function selector switch to “Chiseling” .
2. Position the tip of the chisel at the desired location.
3. Press the on/off switch.
Working at low temperatures:
The hammering mechanism works only when the product has reached a minimum operating
temperature. Briefly position the product on the surface to be worked and run the product under
no load until the required temperature is reached. If necessary, repeat this procedure until the
hammering mechanism begins to operate.