Hilti NURON SF 6-22, Оригинальная инструкция по эксплуатации

Страница: 12 / 192

6 English 2275219
*2275219*
▶
If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 11
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview 1
@
Keyless chuck
;
Torque and operating mode selector ring
=
Side handle
%
Gear selector switch
&
Forward/reverse switch with transport lock
(
Control switch with electronic speed control
)
Grip
+
Work-area light (LED)
§
Installation opening for accessories
/
Battery
:
Release button, battery
∙
Battery status indicator
3.2 Intended use
The product described is a hand-held cordless drill/driver. It is designed for drilling in steel, wood, plastic,
cellular concrete and masonry and for driving and removing screws.
• For this product, use only
Hilti Nuron lithium­ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.4 Overload and overheating indicator
The product has an electronic system to protect against overload and overheating. The product switches off
automatically in the event of overload or overheating. The product might not restart immediately when the
control switch is pressed after being released (cooling phase).