Hilti Nuron GFB 6X-22, Руководство пользователя

Страница: 18 / 64

12 English 2332261
*2332261*
8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶
Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶
Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶
Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery .
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The battery runs down more
quickly than usual.
Very low ambient temperature.
▶
Allow the battery to warm up
slowly to room temperature.
The battery doesn’t engage
with an audible click.
The retaining lug on the battery is
dirty.
▶
Clean the retaining lug and
re-insert the battery.
The product or battery gets
very hot.
Electrical fault
▶
Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
Product does not develop full
power.
A battery with inadequate capacity
was used.
▶
Use a battery with adequate
capacity.
The motor has no braking
effect.
Battery is discharged.
▶
Change the battery and charge
the empty battery.
Product is momentarily
overloaded.
▶
Switch the product off and then
on again.
LEDs of the battery show
nothing
Battery faulty.
▶
Contact Hilti Service.