Hilti IC-BLE, Оригинальная инструкция по эксплуатации

Страница: 18 / 252

14 English 2321964
*2321964*
Trouble or fault Possible cause Action to be taken
LED does not light up when
the operating button is
pressed
Button-cell battery discharged
▶
Change the battery in the
remote control unit. → page 13
Remote control unit faulty
▶
Contact Hilti Service.
LED does not light up (control
switch set to AUTO )
Cable of the receiver module not
correctly plugged into the vacuum
cleaner
▶
Check that plug connection and
cable are correctly installed and
check for faults.
Receiver module not correctly in-
stalled
▶
Install the receiver module on
the vacuum cleaner. → page 12
Receiver module faulty
▶
Contact Hilti Service.
Vacuum cleaner does not
start and/or does not react to
inputs via the remote control
unit
Button-cell battery discharged
▶
Change the battery in the
remote control unit. → page 13
No connection between receiver
module and remote control unit
▶
Make sure that remote control
unit and receiver module are
paired.
▶
Pair the remote control unit
with the receiver module again.
→ page 12
Pairing procedure was aborted or
failed
▶
Repeat the pairing procedure
→ page 12.
Source of trouble is in the vacuum
cleaner
▶
Read the instructions in the
troubleshooting section of the
operating instructions for the
vacuum cleaner.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
10 Manufacturer’s warranty
▶
Please contact your local Hilti representative if you have questions about the warranty conditions.
11 FCC statement (applicable in US) / IC statement (applicable in Canada)
This device has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are intended to ensure adequate protection against
electromagnetic interference when the device is operated in areas used for commercial purposes.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause interference to radio communications. The user must
bear costs incurred due to interference that operation of this device in residential areas can cause.
This device is in compliance with paragraph 15 of the FCC rules and the RSS­210 specifications of ISED.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti may restrict the user’s authorization to
operate the equipment.