Hilti HDE 500-22, Оригинальная инструкция по эксплуатации

Страница: 17 / 68

*2293683*
2293683 English 9
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fall arrest 2
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
▶
Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use the Hilti tool tether #2261970 or #2261971.
▶
Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
▶
Depending on which type of Hilti tool tether is used, secure either the second carabiner or the loop to
the product as shown in the illustration. Check that it holds securely.
Comply with the operating instructions of the Hilti tool tether.
5.5 Inserting the foil pack holder and foil pack 3
CAUTION
Trap hazard Hands can be trapped if care is not exercised when swiveling the foil pack holder closed.
▶
Keep your hands clear of the cradle area when swiveling the foil pack holder into position.
CAUTION
Risk of injury Chemicals hazard.
▶
Check the foil pack holder for damage and soiling. Both pistons must move smoothly and easily in both
directions over the full length of their travel in the foil pack holder. Replace the foil pack holder if it is
damaged and/or badly soiled.
1. Press the release button.
2. Pull the piston rod back as far as they will go.
3. Fit the front end of the foil pack holder into the front locating lug.
4. Pull the foil pack holder on to the rear locating lug and swivel the foil pack holder up.
5. Screw the static mixer (mixing nozzle) onto the foil pack.
6. Push the foil pack into the foil pack holder.
7. Swivel the foil pack holder into the dispenser.
5.6 Inserting the cartridge 4
1. Press the release button.
2. Pull the piston rod back as far as they will go.
3. Fit the front end of the cartridge into the front locating lug.
4. Pull the cartridge on to the rear locating lug and swivel the cartridge up.
5. Screw the static mixer (mixing nozzle) onto the foil pack.
6. Swivel the cartridge into the dispenser.