Hilti GX90-WF, Руководство пользователя

Страница: 30 / 196

22 English 440645
*440645*
Malfunction Possible cause Action to be taken
The tool is fired frequently
without a fastener loaded
The tool is not pressed fully against
the working surface and/or the
trigger is not pulled fully.
▶
Press the tool fully into contact
with the workpiece and do not
release the trigger until the nail
has been fully driven.
Tool has reached its target life of
40,000 fasteners driven.
▶
Clean the tool. → page 21
Jammed piston
▶
Clean the piston. → page 21
Irregular nail projections Tool has reached its target life of
40,000 fasteners driven.
▶
Clean the tool. → page 21
Hard and/or knotty wood
▶
Change the nails or, if possible,
use a different supporting
material.
Empty gas can
▶
Prepare the gas can. → page 18
▶
Insert the gas can. → page 18
Inadequate contact / no base ma-
terial
▶
Insert the nails. → page 20
Working speed too high
▶
Adhere to the maximum fastener
driving rate.
Incorrect piston position Jammed piston (paper, nail or
wood debris in the tool)
▶
Clean the piston. → page 21
The tool doesn’t fire: Tool
indicates that it is ready for
use but when the trigger is
pulled, tool does not fire
Tool not pressed fully against the
surface
▶
Insert the nails. → page 20
Nail jam Nail jammed in the tool nosepiece
▶
Remove the battery and the gas
can.
▶
Remove the jammed nail.
▶
Use a screwdriver to push the
piston all the way back.
Gas can capacity sufficient
for < 1000 nails
Gas loss due to frequent unpro-
ductive pressing against the sur-
face
▶
Press the tool against the
surface only when you intend to
drive a fastener.
The cover of the gas can
compartment will not close
(gas can inserted).
Transport lock on gas can not re-
moved
▶
Remove the transport lock.
→ page 18
Nail driven in too far Nosepiece too far back
▶
Make the settings at the
nosepiece. → page 19
Protruding nail Nosepiece too far forward
▶
Make the settings at the
nosepiece. → page 19
Very flat application angle
▶
Press the tool against the
surface as close to a right angle
as possible.
Tool slips out of position on
the surface
Adapter for surface protection is
fitted to the nosepiece
▶
Use the adapter for surface
protection. → page 19
Fan does not start, LED
flashes red
Battery too cold (<-15 °C) or too
hot (>60 °C)
▶
Remove the battery, warm it up
or allow it to cool down.
▶
Insert another battery.
The fan doesn’t start, no LED
lights
The tool is in hibernation mode
▶
Reset the battery. → page 16
If the problem remains: No battery
power
▶
Insert another battery.
▶
Charge the battery.
Water or moisture in the tool
▶
Care for the tool. → page 21
The fan does not start, the
LED lights up in red
The battery voltage is not sufficient
to operate the tool.
▶
Insert another battery.
▶
Charge the battery.