Hilti CP 660, Инструкция по эксплуатации, Страница: 5 / 64

5
Firestop Foam CP660
Recommendation: Residues in the foil pack should be completely dispensed. The remaining
firestop foam can then be used for the next opening.
5 The foam can be shaped or smoothed by hand (if necessary) after approx. 5 minutes (at 23 °C).
Wear protective gloves!
6
After approx. 10 minutes (at 23 °C) the foam becomes hard and it can then be cut.
–NOTE–
After hardening, any projecting foam can be trimmed off to the specified minimum depth. Trimmed-off
scraps of hardened foam can be placed in the next opening and fresh foam applied around these.
7 Subsequent installation of cables or pipes
Additional cables or pipes can be installed in the opening without difficulty. Do not exceed the approved
maximum number and size of cables or pipes.
1. The cable or pipe may be pushed directly through the foam. Where necessary, use a suitable tool
(screwdriver or drill bit, etc.) to make a hole in the foam before pushing the cable or pipe through.
Do not damage existing cables.
2. Seal any remaining gaps carefully with Firestop Foam CP660.
en
de
fr
it
nl
es
pt
el
da
no
sv
fi
pl
cs
sk
hu
hr
sl
bg
ro
li
lv
et
ru
tr
Additional instructions The firestop foam is not suitable for outdoor applications. The firestop foam is sen-
sitive to UV light and is not weather-resistant . Do not allow the hardened foam to remain in contact with
standing water.
Safety precautions
Danger
Contains: Methylenediphenyl diisocyanate, Ethylenediamine, ethoxylated and propoxylated,
2-Octyl-2H-isothiazol-3-on.
Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. Harmful
if inhaled. May cause allergy or asthma symptoms or breathing difficulties if inhaled. May cause
respiratory irritation. Suspected of causing cancer. May cause damage to organs through prolonged
or repeated exposure. Do not breathe vapours. Wear eye protection, protective clothing, protective
gloves. In case of inadequate ventilation wear respiratory protection. IF ON SKIN: Wash with plenty of
water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present
and easy to do. Continue rinsing. If experiencing respiratory symptoms: Call a doctor, a POISON
CENTER.
Printed: 03.12.2018 | Doc-Nr: PUB / 5167834 / 000 / 07