Hilti AG 6D-22-6, Оригинальная инструкция по эксплуатации

Страница: 19 / 88

*2282187*
2282187 English 13
6.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶
Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶
Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
6.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
6.4 Installing the Hilti retaining strap (optional) 6
When working with the product, you must comply with national regulations for working at heights.
Comply with the operating instructions of the retaining strap.
1. Position the two tabs of the retaining strap accurately on the spark guard.
2. Secure the retaining strap with the corresponding screws through the holes provided in the spark guard.
3. Insert the battery. → page 13
6.5 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the operating instructions of the Hilti tool tether.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶
Secure the retaining strap as described in the section headed Installing Hilti retaining strap → page 13.
Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6.6 Fitting the side handle
▶
Screw the side handle into one of the threaded bushings provided.
6.7 Fitting or removing the guard
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶
Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
▶
Observe the instructions for fitting the applicable guard.