22
7. Operation
●
The supply voltage must comply with the information printed on the rating plate
on the tool. Tools with a voltage rating of 230 V may also be connected to a 220 V
supply.
●
The side handle must always be fitted when the tool is in use.
●
Use clamps or a vice to secure a loose workpiece.
7.1 Structural design considerations
Slits in load-bearing walls are subject to part 1 of the DIN 1053 standard, or other
national regulations and directives.
It is essential that these regulations are observed. The design engineer, architect, or
person in charge of the building project must be consulted before beginning cutting
or slitting work.
-CAUTION-
■
Operation of the tool creates noise.
■
Excessive noise may damage the hearing.
■
Wear ear protection.
-CAUTION-
■
The material may splinter during cutting or grinding.
■
Splintering material may injure parts of the body and the eyes.
■
Wear eye protection, protective gloves and breathing protec-
tion if a dust removal system is not used.
7.2 Operation
-NOTE-
Test new cutting or grinding discs by allowing them to run at maximum speed for at
least 30 seconds.
-CAUTION-
Never use cutting discs for grinding.
7.3 Speed preselection (model AG125-SE)
Material
Application
Disc or insert tool
Speed setting
Plastic
Polishing
Lambswool pad
1
Fine grinding
Felt polishing pad
1
Metal
Fine grinding
Buffing wheel
1
Removing paint
Sanding disc
2–3
Wood, metal
Brushing,
Cup wheel,
removing rust
sanding disc
3
Metal, stone
Grinding
Grinding disc
4–6
Metal
Rough grinding
Rough grinding disc
6
Stone*
Cutting *
Cutting disc and carriage
6
* Use of the carriage (accessory) is mandatory for cutting stone.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069435 / 000 / 00