Hilti AG 100-7, Руководство по эксплуатации

Страница: 13 / 17

noise and/or vibration, for example: maintain the electric tool and accessories, keep the hands warm, organisation of
work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑3 ):
Typical A-weighted sound power level, L
WA
96 dB (A)
Typical A-weighted emission sound pressure level, L
pA
85 dB (A)
Uncertainty for the given sound level, K 3 dB (A)
Triaxial vibration values (vibration vector sum)
Surface grinding, a
h,AG
6.5 m/s²
Uncertainty (K) 1.5 m/s²
Additional information Other applications may produce vibration values that
deviate from the given values.
6 Before use
CAUTION
Wear gloves when fitting or removing parts, when
making adjustments or when remedying malfunc-
tions.
CAUTION
Before using another accessory that is recommen-
ded for the angle grinder in conjunction with the
angle grinders mentioned above, read the operat-
ing instructions for the applicable angle grinder and
observe all instructions.
6.1 Fitting the side handle
Screw the side handle into one of the threaded bushings
provided.
6.2 Guard
6.2.1 Fitting and removing the guard
5
NOTE
The guard is already set to the correct tension by way
of the adjusting screw. If the tension is too low when
the guard is fitted, the adjusting screw can be tightened
slightly to increase the tension.
NOTE
The keyed locating lug on the guard ensures that only
a guard designed for use with the power tool can be
fitted. The keyed locating lug also prevents the guard
from coming into contact with the disc.
1. Release the clamping lever.
2. Fit the guard onto the spindle collar so that the
keyed locating lug engages in the recess provided.
3. Rotate the guard to the required position.
4. Secure the guard by closing the clamping lever.
5. To remove the guard from the power tool, follow the
instructions for fitting the guard but carry out the
steps in the reverse order.
6.2.2 Fitting the front cover
6
Press the front cover onto the standard guard, with the
closed side positioned as shown in the illustration, until it
engages.
6.2.3 Adjusting the guard
7
6.3 Fitting and removing the disc
8 9
NOTE
Diamond discs must be replaced when the cutting or
grinding performance drops significantly. This generally
is the case when the segments reach a height of less
than 2 mm. Other discs must be replaced when the
cutting performance drops significantly or other parts of
the angle grinder (not the disc) come into contact with
the material you are working on. Abrasive discs generally
have to be replaced when the durability date has been
reached.
1. Clean the clamping flange.
2. Fit the clamping flange onto the drive spindle.
3. Fit the disc.
4. Screw on the clamping nut corresponding to the
type of disc fitted
9
.
5. CAUTION Do not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
6. Use the wrench to tighten the clamping nut securely
and then release the spindle lockbutton.
7. To remove the disc from the power tool, follow the
instructions for fitting the disc but carry out the steps
in the reverse order.
en
20
Printed: 19.01.2015 | Doc-Nr: PUB / 5169257 / 000 / 03