1.2.6
Overview of Type VI Camera
DC12V
IN
Mounting Base
Main Body
Lens
Switch Button
Power Cord
12 VDC
Video Cable
Figure 1-6
Overview of Type VI Camera
Note:
Press and hold the switch button for 5 seconds to
switch the video output. Four kinds of video outputs
are available: TVI, AHD, CVI, and CVBS.
2
Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1
Installation of Type I and Type II Camera
Before you start:
Type I and type II cameras share the same installation,
and we take type I camera as the example to describe
the installation method.
Both wall mounting and ceiling mounting are suitable
for the camera. We take ceiling mounting as an example
in this section. You can take the steps of ceiling
mounting as a reference, when adopting wall mounting.
Steps:
1.
Disassemble the turret camera by rotating the
camera to align the notch to one of the marks, as
shown in the figure below.
Mark
Notch
Figure 2-1
Disassemble the Camera
2.
Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3.
Paste the drill template (supplied) to the place
where you want to install the camera.
