Hillyard TRIDENT T26SC PLUS, Руководство по обслуживанию

Страница: 26 / 62

4.4.2 Traction Gearmotor
• Put the machine in safe conditions.
• Disassemble both wheels
(see section
4.4.1 at page 25 )
.
• Remove the 4 screws fixing the gear-
motor to the frame and bearing sup-
port
(see fig. 4.4.2-23 )
.
• Unplug the Electrical connector of
the Traction Gearmotor.
• Remove the fixing screws of the
bearing supports paying attention to
the gearmotor which will be free to
fall off to the ground
(see fig. 4.4.2-24 ) (see
fig. 4.4.2-25 )
.
• Remove the drive shafts and remove
the bearings
(see fig. 4.4.2-26 )
.
• Proceed at reverse to refit the part.
4.4.2-23 4.4.2-24
4.4.2-25 4.4.2-26
4.5 Solution Delivery Sys-
tem
4.5.1 Solution Tank
• Put the machine in safe conditions.
• Remove the recovery tank
(see section
4.3.5 at page 24 ) (see fig. 4.5.1-27 )
and the elec-
tric system carter
(see fig. 4.5.1-28 )
.
• Remove the handlebar and the elec-
trical system panel
(see fig. 4.5.1-29 ) (see fig.
4.5.1-30 )
.
4.5.1-27 4.5.1-28
4.5.1-29 4.5.1-30
• Remove the rear carters
(see fig. 4.5.1-31 )
.
• Remove the lower and front screws
that secure the tank to the frame
(see
fig. 4.5.1-32 ) (see fig. 4.5.1-33 )
.
• Remove the lower carters and the
water assembly
(see fig. 4.5.1-34 )
.
• Remove the remaining parts
(see fig.
4.5.1-35 )
.
• Proceed at reverse to refit the part.
26