19
Chapter 1 Product Profile
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
3.
Rip off the label stuck on the slot.
4.
Push the SD card slightly and it will pop out.
Note: Hillstone recommends Kingston and SanDisk SD cards of 16GB and 32GB. To
ensure the storage writing speed, the SD card should have a speed of Class 4 at least.
CLR Button
The CLR button is the pinhole of the front panel and is used to reset the appliance
back to the factory default settings. You can restore access to the appliance with this
button if the login password is lost.
Warning: Use this button carefully. Resetting the appliance clears all existing
configurations.
To restore the factory default settings, take the following steps:
1.
Turn off the power of the appliance.
2.
Press the CLR button in the pinhole and switch on the power supply
simultaneously.
3.
Keep pressing till the STA and ALM LEDs turn to constantly red, then stop
pressing. The appliance begins to restore to the original factory settings.
4.
The system reboots after the default settings restored.
Cooling System
The cooling system consists of two fan trays each of which has six fans and an air
filter. The fan trays are vertically located in the Fan0 slot of the front panel and Fan1
slot of the back panel. Both the fan tray and air filter can be replaced (see
Figure 1-18: Fan Tray
