Page
2
of
4
RB31188 Iss-2 13APR17 ©Hills Limited 2017
www.hills.com.au/antenna
1300 445 571
4.
MOUNTING BOOM
Rotate the mounting boom so that it
is perpendicular to the screen, as per
Figures 4 & 6. Use the bolt and nut
from the accessory bag to secure the
mounting boom in the correct
position and tighten. See Figure 4.
5.
U-BOLT ASSEMBLY
Note: The antenna can be mounted for
horizontally or vertically polarised signals.
Check the local transmitter to determine
the correct mounting orientation. See
Figures 7 & 8. Remove the U-bolt, nuts,
rubber flange and clamps from the
accessory bag. Place the U-bolt through
the mast clamp, rubber flange then
through the tilt bracket and affix the
flange nuts. Fit the tilt bracket over the
mounting boom. See Figure 5.
6.
MOUNTING THE ANTENNA
Take the pre-assembled U-bolt assembly and
loosen the flange nuts sufficiently to allow the
mast to fit between the mast clamp bracket
and the U-bolt. Slide the U-bolt over the mast
and tighten the nuts finger tight (see Figure 6).
7.
ALIGNING THE ANTENNA
Aim the antenna towards the transmitter and
tighten the nuts with a spanner. Do not over
tighten the nuts so as not to excessively
squash the rubber flange. Secure the cable to
the mast with cable ties, being careful not to
exceed the minimum bending radius of the
cable (see Figure 6).
Towards
transmitter
Figure 4
Figure 5
Figure 6
MAIN BOOM
T-PLATE
BOLT
NUT
CLAMP
U-BOLT
MAST
BOOM
BRACKET
NUT
FLANGE
Page
3
of
4
RB31188 Iss-2 13APR17 ©Hills Limited 2017
www.hills.com.au/antenna
1300 445 571
INSTALLATION TIPS: For best results mount the antenna outdoors, as high on
the mast as possible and clear of any obstructions between the antenna and
the transmitter.
WARRANTY TERMS – Australian Consumer Law
1.
Hills Antenna & TV Systems provides consumers with the following warranty in
relation to this Equipment, in addition to complying with the requirements of any
relevant legislation, including the
Competition and Consumer Act 2010
(Cth) in
Australia and the
Consumer Guarantees Act 1993
in New Zealand (the
Acts
),
except where a New Zealand consumer acquires the relevant Equipment for the
purposes of a
business.
2.
In this warranty, we have used the following definitions:
(a)
Hills Antenna & TV Systems
,
our
or
we
means Hills Antenna & TV
Systems, a division of Hills Limited ABN 35 007 573 417 of Level 7, 130 Pitt
Street, Sydney, NSW 2000.
(b)
Equipment
means the goods packaged with this warranty document, or to
which this warranty document is affixed.
(c)
Material
means a material or component used by Hills Antenna & TV
Systems in the manufacture of the Equipment.
(d)
Warranty Period
means 5 Years from the date of purchase of the
Equipment.
If the Equipment or part (as the case may be) is repaired or replaced, there
will be no extension to the original warranty period.
(e)
Workmanship
means the handling, assembly and manufacturing processes
performed by or on behalf of Hills Antenna & TV Systems in order to
manufacture the Equipment.
3.
Hills Antenna & TV Systems warrants that for the duration of the Warranty Period,
the Equipment will be free of faults arising from defects in Workmanship or
Materials, on the terms and conditions set out in this warranty.
Figure 7
– Mounting for
vertical polarisation
Figure 8
– Mounting for
horizontal polarisation
