Hill Audio RPL-1000, Руководство пользователя

Страница: 5 / 8

PAGE 4
Functional Description
The RPL1000 is a dimmable LED rack light, a power conditioner, a power distributor, an AC line volt
meter and a USB 2A charger in one unit. The power conditiong function protects all connected equip-
ment from surges and spikes, and a built-in circuit breaker provides overload protection.
2
1
3
4
7
8
6
5
Power switch. This switch switches the complete unit on and off, including the USB charger
section (6), the racklight (3 & 4) and the rear-side power outlets (7). Note that in case the fuse
breaker (2) was tripped, the unit will be off even if the power switch is on.
Fuse breaker. This is a 15A fuse breaker in series with the power switch, which will trip if the
total power drawn through the power cord (8) exceeds 15A. If the breaker was tripped, switch
the unit off via the on/off switch (1), reduce the connected load, press the actuator on the
breaker and power the unit up again via the power switch (1).
LED light. This is a downwards-directed LED strip with daylight colour temperature. Provided
this unit is mounted in the top position of a rack, it can illuminate the user surfaces of devices
mounted below. The LED light can be switched on and off and adjusted in its brighntess via the
dimmer control (4).
LED light on/off switch and brightness control. Turn this fully counterclockwise to reduce the
brightness and turn it over the detent at the fully counterclockwise position to switch the LED
light (3) off. Accordingly, turning it clockwise switches on and increases the brightness of the
LED light (3).
AC Volt Meter. This display indicates the current voltage of the AC supply to which the power
cord (8) is connected, in full volts, with about 1% accuracy. This is helpful to determine
whether malfunction of equipment may be related to AC supply issues.
USB charging port. This is a USB type A socket, where the USB power lines carry 5V DC and
deliver up to 2A of current. This is sufficient to also charge devices with larger current require-
ments such as tablet computers.
ATTENTION:
This port provides 5V DC regulated voltage. No current regulation is provided how-
ever, so this port is only suitable for charging devices with on-board charge
current management. The manufacturer of this product does not accept any liabil-
ity for charging compatibility and subsequent potential damages.
Switched AC Outlets. These are ten IEC 60320 - C13 outlets, which are switched on and off
simultaneously via the power switch (1). Each single outlet is limited to 5A load, each group of
5 outlets limited to 8A, while the total load of all ten outlets together may not exceed 15A. If
the load exceeds 15A, the circuit brealker (2) will trip. It is thus not recommended to connect
devices such as incandescend lamps, fog machines or high-power audio amplifiers to these
outlets. The voltage available at these outlets is filtered for spikes, surges and RF.
AC cord. The AC cord is fixed to this unit and shall not be removed or replaced by other AC
cords. Any extension must be able to carry the same power (250V/16A). It is essential that
the outlet to which the power plug is connected is properly earthed, as otherwise no earthing
will be provided to any devices connected to the AC outlets (7), which may result in unexpected
performance for equipment which requires proper earthing, or in safety risks.
ATTENTION:
This product is not a power sequencer, so all outlets will be switched on and off at
the same time. If power sequencing is needed to reduce the surge current during
powering up, this product is not suitable.
USER MANUAL - RPL1000 RACKLIGHT | POWER CONDITIONER | USB CHARGER