PAGE 6
25
21
22
23
24
26
4
Most controls and functions of the stereo channels are identi-
cal to the mono channels, with the exception of no compres-
sors provided and other differences outlined below. For any
not listed item, refer to the mono channel section.
Gain control. Like in the mono channels, this adjusts the input
gain to achieve the best signal/noise ratio. Try to set the
control in a way that the Level LED (5) shortly lights up at level
peaks of the signal. Specifically with line sources, pay attention
to whether the source has a volume control. It can be better
to use a higher source volume than too much gain at the
mixer’s input stage. As an exception, it has to be noted that for
stereo inputs 9-10 and 11-12, the gain control only works on
the microphone input (1), not on the line inputs (21). For
stereo inputs 13-14 and 15-16, the gain control works on the
line inputs (21).
Line Input. These are two balanced 6.35mm TRS connectors.
Connect any line level stereo source here.
USB Source selector (only channel 11-12). Pressing this
button will route the channel to the output of the internal USB
audio interface. Note that the input jacks (21) are disabled
when this button is pressed.
AUX Input and source selector (only channel 13-14 and
15-16). These channels have a 3.5mm stereo TRS
(unbalanced) input, suitable for the connection of e.g. MP3
players. This AUX input is activated by pressing the relative
button, in this case the channel’s stereo TRS inputs (21) are
disabled.
High-Mid EQ. This is a fixed frequency peaking EQ, with a
center frequency of 3 kHz.
Low-Mid EQ. This is a fixed frequency peaking EQ, with a center
frequency of 500 Hz.
BALANCE control. This control allows to position the channel
signal in the stereo image. Turning the control counterclock-
wise will balance the signal more to the left output, turning it
clockwise will balance the signal more to the right output. The
center position sends the left channel of the signal to the left
main output and the right channel of the signal to the right
main output. Note that “left” and “right“ may be inversed if the
channel is routed to a subgroup and the subgroup is assigned
to the main bus in an inverted manner.
Stereo Input Channels
1
4
7
5
8
11
12
14
13
16
20
18
19
17
B
C
21
22
23
25
24
26
USER MANUAL - LMR2442FX-C-(U) Rackmixer
Содержание Multimix LMR-2442-FXC
Страница 1: ...RevA 08 2015 PARAM TAP...
