PAGE 3
2
1
3
4
5
7
6
9
10
8
11
USER MANUAL - LMR1202FX RACK MIXER
2
1
3
4
6
5
AC inlet and fuse holder. Use the supplied AC cord to connect the unit to AC mains. Make sure
voltage and frequency stated and set on the unit comply with your local AC supply. The fuse
can be accessed by the small drawer at the AC inlet. To change the fuse, unplug the AC cord
first, pull out the fuse drawer and replace the fuse ONLY with a fuse of SAME voltage and
rating. If the fuse blows again after replacement, hand over the unit to qualified service person-
nel.
POWER switch. Switches the unit on and off. Make sure to switch the unit off when not in use.
PHANTOM POWER switch. This switch activates a 48V DC supply to the MIC inputs (11) for
powering condenser microphones. Phantom power shall remain switched off if only dynamic
microphones are used. The on/off status is indicated by a front-panel LED (21).
MAIN OUTPUT section. This contains a pair of XLR outputs which carry the balanced main mix
signal.
CONTROL ROOM OUTPUT. This is a pair of TRS connector carrying the same signal as the
front-panel headphones connector (27)
2TRK In/Out. This is a dual pair of unbalanced RCA stereo connectors for a tape or solid state
recorder in order to record from the main mix and replay into the main mix. The signal routing
can be determined by the relative front-panel switches (26).
12
Содержание LMR-1202FX
Страница 1: ...RevA 09 2017...
