Fault Finding
FAULT DESCRIPTION
PROBABLE CAUSE
False or no response
Steep slopes or thin bars.
Bushes or other foliage could absorb the
signals. Electricity wires nearby could
interfere with the signal. (See diagram
below)
Sensors covered with snow, mud or ice etc.
Power light does not come on when reverse
gear has been chosen.
Check that the power wires are properly
connected to the reversing light power
wires.
Check that the snap-on connectors are
providing a good contact.
Sensor always shows an object is FT (Red
LED) behind vehicle.
Check whether the sensors are located to
low, or the angle is pointing downwards and
therefore detecting the ground.
Power light (Green LED) is on, but the unit it
not detecting any obstacles
Check whether the sensors cable is
correctly plugged into the 2 pin socket of the
main unit.
Unit does not show correct distances.
Check that the sensor is properly mounted.
The sensor must be horizontal.
Adjust as necessary.
SPECIFICATION
Power requirement:
DC10 - 15V
<30mA stand-by
<200mA Alarming
LED indicator:
3 position LED
Power indicator:
Green LED
Detection range:
5.0ft, 3.5ft, 2.0ft
Closest detection range: 0.4mtr (15inches)
Alarm volume select:
High, Medium, Low
Temperature:
-20°C to +50°C
Length of cable:
5mtrs (16.5ft)
-6-
Содержание PDC200
Страница 1: ...Wired Parking Aid 2 Sensors PDC200...
