Hilberling PT-8000A, Руководство по эксплуатации

Страница: 39 / 122

PT-8000A Operating Manual v2.00.33
31
If one of the softkeys (144/50/28) is pushed and held the transverter operation
frequency band is displayed instead of the standby VFO frequency, see Figure
35.
Using control STEP-VFO /
MEM/CH gives access to all
transverter operation frequency
bands as listed below (Table 15).
When releasing the transverter
softkey the new frequency band is
transferred and will be stored.
The following 13 transverter operation frequency bands are available:
No. Frequency Range
1 432 ... 434 MHz
2 435 ... 437 MHz
3 1.268 ... 1.270 GHz
4 1.296 ... 1.298 GHz
5 2.320 ... 2.322 GHz
6 3.400 ... 3.402 GHz
7 3.456 ... 3.458 GHz
8 5.760 ... 5.762 GHz
9 10.368 ... 10.370 GHz
10 10.450 … 10.452 GHz
11 24.048 … 24.050 GHz
12 47.088 ... 47.090 GHz
13 75.976 ... 75.978 GHz
Tab. 15
When the PT-8000A operates in transverter mode the transmitter output is
directed to the TX-ext. connector on the rear panel (see Page 5 / Table 3 /
socket J14).
A transverter for one of the bands shown in Table 15 must be selected so that it
can operate properly with drive power 10 m, 6 m or 2 m.
Maximum power level at J14 is +20 dBm.
Hooking up multiple transverters requires external distribution of TX signals
from TX-ext. J14.
Changing of allocated
transverters
Transverter Operation
Frequency Bands
Fig. 35