WIRE LOOP
ASSEMBLY
MAKE SURE THE HEATER PANELS ARE FOLDED DOWN BEFORE
MOUNTING THE HEATER ONTO THE UMBRELLA.
1. Remove the heater brace from the heater body by sliding it downward,
please see FIG 1.
3. Place the heater onto an umbrella pole between 1’’ (25mm)
and 2’’(50mm) in diameter by inserting the pole into the slot, please see
FIG 2.
3. Place the heater brace back on by sliding it upward, please see
FIG 3.
4. Secure the heater to the umbrella pole by turning locking screw
clockwise until the heater is secure on the umbrella pole.
5. Use the wire loop at the end of the heater panel, pull the heater panel
up until a click is heard, This means that the panel is now locked into
position.
NOTE: DO NOT FOLD THE PANELS DOWN WITHOUT FIRST
PUSH THE LOCKING PIN IN.
6,
FOLD DOWN ANY OF THE HEATER PANEL
Press metal locking pin at the hinge of the heater panel, then hold wire
loop at the front end of the heater to fold down the panel.
NOTE: WAIT UNTIL THE HEATER PANELS HAVE ALL COOLED
DOWN BEFORE FOLDING THE HEATER PANELS DOWN.
7. When any of the heater panels is folded down while the
heater is on, that panel will shut off, because on the back of the panel is a
minor switch so that only two or one heater panel can be used.
FIG 1
FIG 2
FIG 3
LOCKING PIN
