F600X Flash lamp user manual Version: A1
5.2 F6000 should be installed with bracket and perpendicular to the ground
.
The interpretation and ownership of this manual belong to Hiland company.
Any change of the product can be without prior
notice
7
．
Connect the power and antenna
wires with terminals.
4
．
Put the power wire and antenna
through the hole of bracket, fix the
holder with TA4*30 screw on the wall
5.
Put the power wire and antenna
through the hole of holder, fix the holder
on the bracket with PA4*10mm screws.
8
．
Install the case, and make sure the
fastener fixed with the holder. Then
screw up the antenna clockwise.
7.
扣上上盖，注意将灯罩托板的卡扣和底
座扣好，然后将天线顺时针方向拧紧。
User must install the lamp with bracket and
make the lamp perpendicular to the ground
Make sure the lamp not install slantwise
to avoid water gets inside the lamp
6. Make sure the Sealing ring
installed correctly into the Groove
on the holder.
9
．
Fit the cover case on the holder
without gap. And twist the antenna
until it’s getting tight
OK
NG
