HIKVISION UD08391B, Руководство пользователя, Страница: 34 / 139

Network Camera User Manual
25
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface: Configuration > System > System Settings >
RS485 .
RS-485 Settings
2. Set the RS485 parameters and click
Save
to save the settings.
By default, the Baud Rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and
the Parity and Flow Control is None.
Note:
The Baud Rate, PTZ Protocol and PTZ Address parameters should be exactly
the same as the PTZ camera parameters.
Configuring Infrared Light
Purpose:
The camera has four sets of infrared lights which can be enabled or disabled
separately. The four sets of infrared lights are named as No.1 to No.4 clockwise
starting from the dial mark 0° to 270° on camera body. You can hover on the icon to
see the figure.
One-to-One Control: With one-to-one control enabled, you can bind certain set of
infrared light to certain camera channel. Thus the infrared light only works along with
the bound camera channel.