Steps:
1.
Drill four screw holes in the wall according to the
holes of the mount.
2.
Install the mount to the wall by aligning the four
screw holes of the mount with expansion screws on
the wall.
3.
Secure the mount with four hex nuts and washers.
Type I Camera
Type II Camera
Figure 2-17
Install the Mount
4.
Install the mounting base of the turret camera to
the wall mounting bracket, and secure them with
supplied screws.
Type I Camera
Type II Camera
Figure 2-18
Install the Mounting Base to the Bracket
5.
Route the cables through the mount.
6.
Repeat steps 7 to 9 of 2.1.1 Ceiling/Wall Mounting
without Junction Box to complete the installation.
2.4
Ceiling Mounting of Type III Camera
Steps:
1.
Disassemble the turret camera by rotating the
camera to align the notch to one of the marks, as
shown in the figure below.
Mark
Notch
Figure 2-19
Disassemble the Camera
2.
Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3.
Paste the drill template (supplied) to the place
where you want to install the camera.
4.
Drill the screw holes and the cable hole (optional)
on the ceiling/wall according to the drill template.
60 mm (2.36" )
Ø 3
0 m
m
(1.
18
" )
Ø 77.
5 mm
(3.05
" )
2- Ø 4
.5 mm
(0.18
" )
Figure 2-20
Drill Template