Clip Plate
Figure 2-8
Remove the Clip Plate
4.
Fix the mounting base on the ceiling with screws.
Figure 2-9
Fix the Mounting Base on the Ceiling
Note:
In the supplied screw package, both self-tapping
screws and expansion bolts are contained.
For cement ceiling/wall, expansion bolts are
required to fix the camera. For wooden ceiling/wall,
self-tapping screws are required
5.
Route the cables through the cable hole, or the side
opening.
6.
Install the main body to the mounting base and
insert the clip plate.
Figure 2-10
Install the Turret Camera
7.
Tighten the screws with the wrench.
8.
Connect the corresponding cables, such as power
cord, and video cable.
9.
Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].