User Manual for NVR Server
2.2.3 Start the Server
Server checks HDDs for partition formatting status and data consistency from the second start up
on and it will repair the abnormal HDDs in few seconds automatically and show a message as
below. If require succeed, the server will be initialized after that, manually repair is required while
the operation fails, then the server will begin to initialize
.
2.2.4 Stop the Server
A confirm dialogue for stopping the Server will pop up when the “Stop” button on the main
interface has been clicked, to avoid the case of stopped by accident. Click “Yes” if truly want the
Server to stop, or else click “No”, and the running state of the Server will remain the same
.
Note: Stopping the record plan won’t stop the remote control service or the VOD service.
These two services will be stopped only after the Server exit.
2.2.5 System configuration
NVR server requires system configuration in the first start up, after that, users may enter “Config”
button in the main interface to configure, e.g. HDD groups, monitor port…and so on. For details
please refer to 2.2.1 running for the First Time. Software restart is required if the configuration is
modified
.
2.2.6 Exit
When you click on “exit” in the main interface, it will quit if the server is not started. Otherwise, a
dialog box is displayed to prompt users to close the server first
.
Note:
If the server quits due to exception such as out of power, it will require disk repair in the
next start up because of incomplete HDD data
.
- 8 -
